Job DescriptionJob Summary.Machine Operator responsible for the manufacturing of Power Section (Stator & Rotor) by following procedures and SOP
ResponsibilitiesRESPONSIBILITIES/ACCOUNTABILTY & AUTHORITY:
- * Manufacturing Stators and Rotors for usage in oilfield directional drilling
- Follow procedures related to stator and rotor manufacturing process
- Review of the necessary manufacturing procedures frequency to be fluent and aware of the critical parameters related to the process
- Verify quality control checks at each manufacturing process, prior to planning or transferring the job to the next process of manufacturing
- Support and participate in the Organizations Continual Improvement program and any problem-solving initiatives
- Follow the operating procedures (SOP) and perform the task based on the Job Hazard analysis performed
- Operation of overhead cranes in the movement of parts or products
- Report any abnormalities or variations observed in the manufacturing process to the concerned parties
- Ensure the tools, gauges and equipment’s used in manufacturing are maintained properly
- Document and maintain checklist, paper routers, or any ERP system that are in place
- Assist and support in the repair work of any machine or areas in the facility
- Handling of products, tubes & core at elevated temperatures by following the necessary safety procedures
- Follow the house keeping as per the 5S requirements
- Suggest or raise observation on any improvements, risk, safety concerns and good practices
- Ensure to comply with all NOV HSE procedures and policies and maintain relevant HSE logs
- Observe HSE regulations, encourages safe working practices, corrects obvious hazards immediately or reports them to the proper personnel
Behavioral Skills/Competencies & Experience Required
- * Perform daily operator checklist of machines
- Capture/measure necessary process parameters and record the readings
- Ensure controlled use of elastomer & chemicals issued to shop floor
- Check the stator or rotor prior to starting any process and report if in doubt
- Ensure the stator/rotor is processed to the next step only after complete review of task performed
- Ensure machines are running as per the requirement
- Operate Boiler, Generator, Air compressors, Forklift (License/Certification required) when needs/advised
- Assist maintenance technicians when critical machine breakdowns are been attended
- Provide training to any new hire / operators that are under the certification program
- Other duties, as assigned by the supervisor
QualificationsQualifications: (Education/No. of Years of Experience)
- * High School Diploma or equivalent with knowledge in basic math
Skills, Training, Special Knowledge, And/or Language Skills
- * Knowledge of the proper use of measuring tools/gauge and tools
- Understand routers, drawings and procedures
- Able to communicate in English (both writing and orally)
- Understanding of pneumatic, hydraulic, basic electrical systems and with mechanical aptitude. Experience in safe use of power tools used in Manufacturing Industries
Quality Assurance
- * Ability to understand basic engineering drawings
- Ability to present and explain basic technical information to diverse audience
- Ability to document, store and retrieve information as per basic QMS
